PCB vacuum loader SMT suction machine-SMTlink
The PCB Vacuum Loader SMT suction machine is used for the SMT manufacturing line and has a PCB board that cannot easily shatter thanks to a special air circuit design. With steel structural welding, the design is strong and robust. Both the plate feeding mode and the suction plate mode can be used depending on the PCB’s thickness, the push rod’s location can be changed and has SMEMA signal interface standards.
PCB vacuum loader SMT suction machine
SMTlink is delighted to sell this PCB Vacuum Loader SMT suction machine. It is utilized for the SMT manufacturing line, as well as for feeding the work board, and one of those who has already used it says, ” it’s so nice to use, I don’t regret my decision to acquire it.”
One of the best features of this machinery is that its touch screen monitor is faster, more high-tech, and that you can really save time and money with this product. It also has a 230V AC, single-phase maximum 300 VA Power supply and electrical load, so it doesn’t consume too much electricity when compared to other machines.
SPECIFICATION:
- Bin count: 1 on top conveyor, 1 on bottom conveyor.
- Board duration: 6 seconds or as determined by the user
- Bin replacement duration: 20 seconds or as requested by the user
- 10, 20, 30, 40 mm or user-specified steps are available.
- Electrical load and power source: 230V AC, single-phase, maximum 300 VA
- 4-6 bar of air pressure and up to 10 l/min of air flow
- Minimum Board Thickness is 0.6mm
- Left to right, then left to right, then left (according to customer requirements)
- short duration between bin changes (20 seconds)
- Pressure of the air supply: 4-6 bar, up to 10 l/min
Features:
- With steel structural welding, the design is strong and robust
- Adjustable width bin conveyor
- increased frame capacity
- touch-screen display
- With alarm bell
- Has full assurance of security
- Implement PLC control.
- Touch screen technology serves as the user interface.
- The PCB board cannot easily be broken because of the unique air circuit architecture.
- The precise positioning of the material box may be guaranteed by a point pneumatic clamp.
- Both the plate feeding mode and the suction plate mode can be used.
- Depending on the PCB’s thickness, the push rod’s location can be changed.
- display of fault codes for self-testing.
- Cable that resists wear and is difficult to damage.
- SMEMA signal interface standards.
